Announcement

Collapse
No announcement yet.

Elecronic ballast compatibility with bulbs

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Elecronic ballast compatibility with bulbs

    Hi guys,

    need some advice about lighting. I'm about to buy 2 coralvue 400w electronic ballast and 2 lumenarc reflector to replace my 2 gieseman 400w projectors. I was just wondering if those coralvue could lit and run properly my new BLV nepturion 14000K SE? I sent a mail to coralvue asking the same, but I didn't get no answer. Can one of you lit my candle?

    Thanks

    Oli
    zeo-padawan fighting the brown side of the force

  • #2
    Oli, not sure why they couldn't.. My CV never failed to fire any bulb I tried and my friend even used DE with his...

    Jeff

    Comment


    • #3
      Oli, they probably don't know b/c we don't have the 14k BLV in the US (400w), AND they are still getting there act together after Katrina. that being said, there's no reason it shouldn't light the bulb.
      10x3x2 FOWLR (for now)
      BK400ext
      RD12 return, 2 RD12 closed loop, wavebox with extension
      MRC kalkmixer
      IKS

      Comment


      • #4
        Thanks for replies guys.
        I had some doubt because the curent needed by the bulb is 4Amp and the ignition voltage is 4 KV. As CV doesn't give informations about these parameters, i was just wondering if somebody had already tested this combination.

        Oli
        zeo-padawan fighting the brown side of the force

        Comment

        Working...
        X